| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-21-2008, 04:29 PM
| |||
| |||
hello i m cutting NITRONIC material i have to remove 1.063in. i m using 350 speed and feed is 20.0ipm.....but insert get dul after 4 pices so can soem help me what speed & feed i could use...i m using round insert wich has 6 corner ( sandvik insert) and 5insert percutter...thnx for help  |
|
#2
07-21-2008, 06:56 PM
| |||
| |||
| Hi "Slow speeds, positive feeds and abundant resulphurized lubricant are essential to success in machining this alloy. Speeds and feeds similar to those employed with 316 or 317 stainless are appropriate here. All common machining practices can be used on this material. Chips will be tough and stringy and it is recommended that curlers or breakers are used. " regards
__________________ ---------------- Can't Fix Stupid |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed & Feed | kal_pesh | Mastercam | 4 | 02-23-2008 01:19 PM |
| Speed & Feed | kal_pesh | General CAM Discussion | 1 | 02-20-2008 10:15 PM |
| speed and feed again | fourperf | Fadal | 13 | 01-25-2007 03:53 AM |
| Speed and feed... | kombayotch | General Metalwork Discussion | 13 | 03-07-2006 07:12 AM |
| speed and feed | KBW | General CAM Discussion | 2 | 02-20-2004 09:18 PM |
| | |
Linear Mode
