| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
06-17-2008, 12:39 PM
| |||
| |||
| This is probably hard coded in for some reason, it can be taken out in peof or pretract. what post is this from? Steve www.cad2cam.net
__________________ www.cad2cam.net Programmer/ Certified Cam Instructor  |
|
#3
06-18-2008, 08:02 AM
| ||||
| ||||
| is this for lathe? as I see this as a home reference like a G28,G30. I also see you have a G54 at the end. notice the G128 at the end of my lathe op. (TOOL - 9 OFFSET - 9) (FINISH OD FINISH RIGHT / 35 DEG. INSERT - VNMG-431) G128G0X0.Z0. G0T0909 G97S218M03 G0X3.498Z.549M9 G50S3200 G96S200 G99G1Z.349F.01 G2X3.7908Z-.0046R.5 G1X3.9908Z-.1046 G3X4.Z-.1157R.0156 G1Z-1.3376 G2X4.2929Z-1.6911R.5 G1X4.4343Z-1.6204 G0X4.5071 Z.3464 G1Z.1464 G3X3.8Z0.R.5 G1X1.9 G3X1.1929Z.1464R.5 G1X1.3343Z.2172 M9 G128G0X0.Z0. G91G28U0.W0. M30 %
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
