| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-19-2008, 06:40 PM
| |||
| |||
Is there a "deal" that will give me a estimated run time with master cam 9 based on the programmed feeds and speeds of the program? If so where is it? If not is there something out there that does? Thanks Leroy  |
|
#2
05-19-2008, 07:36 PM
| |||
| |||
| Hi: In the main menu,NC utilities,setup sheet (operation tab, just click on the tool icon at the LH side). It uses your post (where you have correctly entered the toolchange time and rapid) to calculate the run time. regards
__________________ ---------------- Can't Fix Stupid |
|
#3
05-19-2008, 09:00 PM
| |||
| |||
| Thanks, I knew it had to be there somewhere. Leroy |
|
#4
05-20-2008, 08:50 AM
| ||||
| ||||
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Run Time | Tazzer | Haas Mills | 2 | 03-28-2008 08:46 PM |
| Need more time...! | Scratch | CNC Plasma and Waterjet Machines | 3 | 07-11-2007 07:12 PM |
| milling time (not to be confused with hammer time) | barefoot0 | G-Code Programing | 4 | 05-02-2007 06:18 PM |
| X2 Conversion Time (shopping time) | Micro Rotors | Benchtop Machines | 2 | 03-04-2007 11:11 AM |
| have you time to look | watzmann | CNCzone Club House | 4 | 10-12-2006 11:26 AM |
| | |
Linear Mode
