| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-10-2004, 03:35 PM
| |||
| |||
| mastercam9 and toshiba notebook bought one with a pentium4 and 512 of ram and it wont work it slows it down so bad i have an ati video card in it that may be the problem duz anyone have any tricks that i might be able to do to make it work thanks ken    |
|
#2
08-10-2004, 04:01 PM
| |||
| |||
| try the http://www.guru3d.com/rivatuner/ see if you can hack it into a "FireGl" card  what chipset do you have in the laptop? |
|
#3
08-10-2004, 04:09 PM
| ||||
| ||||
| Turn all your hardware accel off while running MC with an ATI card. I've got an ATI on a Sony Vaio with all accel off and it works good except for some cursor 'ghosts' once in a while.
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
