MASTERCAM X2 QUESTION POCKETS

[mt15racing]

I am currently running mastercam X2 SP1 and I have a couple questions. First off and most important for some reason when I am pocketing when I tell the tool to stay down on the Roughing/Finishing parameters and for some reason it still comes up on the finish pass around the outside of the part. I have also tried clicking the keep tool button in the depth cuts tab and it still wants to lift up between the roughing and finishing pockets. I have tried to turn off cutter comp, turn of lead in lead out and nothing seems to work. For some reason the tool wants to come up in between cuts. My next question was when I post some times I get a G41 line on a G02 or G03 line, not sure if anyone else has had this problem and if there is an option in mastercam configuration or if it is something I must change in my post. But this occurs very rarley.

[tstom]

I think the only way the tool will stay down is to turn off the finish op

[cnc-king]

set your retract to incremental zero the reason you are getting g3g41 is your lead in set your lead in to tangent set the line lead in long than than the arc lead in with a 90 deg
see attachment

[cnc-king]

wrong attachment- correctment