Question - CNCzone.com-The Largest Machinist Community on the net!

Turbine · #1 05-03-2003, 08:09 PM

I knew that get your attention.

What are the limitations on 5 axis simultaneous interpolation
capability in Mill level 3 ? (as opposed to the multi axis version)
Can it be done at all?

cadcam · #2 05-03-2003, 10:44 PM

What is the Multi axis version because that would be the L3 version.

Now what specific are you looking for?
I so true multi axis up to 5.

Do you want to know to we support 5 axis swarf with controled fanning and control of Axis limitations?

We have alott of control of the tool compared to few years ago.
We support full multi surface 5 axis and more.

Turbine · #3 05-04-2003, 09:25 PM

Ahh.....I thought there was a difference.
Thanks.

cadcam · #4 05-04-2003, 10:08 PM

Turbin sorry if I came over a little harsh. after reading my response I feel I was .

Feel free to ask more if there is some thing spacific you are looking for.

Have a good week.

Turbine · #5 05-05-2003, 07:30 PM

It didn't come over harsh. Hurried maybe.
I just thought there was another version, above level 3 with more bells and whistles.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Extremely basic machining question.	touser	General Metalwork Discussion	9	06-19-2005 01:51 AM
Question about power supplies	dowling177	General Electronics Discussion	1	01-28-2005 08:01 AM
Hobbycnc controler question	chas	Hobbycnc (Products)	3	09-09-2004 06:00 PM
Just a question about plunge milling.	Machine1	Hard and High Speed Machining	4	01-28-2004 09:36 PM
HF lathe question	rs1300	General Metal Working Machines	0	01-19-2004 12:22 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)