Post Processors for MastercamX

[Ed Williams]

It been a couple years since I did this. I can't remember how to add a Post Processors to matercam. I have the Post Processors file. I'm changing computers.
Thanks Ed

[dpark1]

go to your mcam folder-mill-posts, then paste your post file in.

[cadcam]

What version as this has changed after MC9?

[cadcam]

What version are you running as after V9 this has changed. there is also more then just the PST file. once agian matters what version.

[Ed Williams]

I had all the files. I just for got where to put them. Everything works fine now.
Thanks Ed

[yaoyu]

you can using the UpdatePost.dll add a Post Processors to matercam.

select [settings]=>[Run User Application] open Updatepost.dll

[yaoyu]

look this video
http://www.3322.com.cn/readfile.aspx...322_1-22901-35
or

[cadcam]

(you can using the UpdatePost.dll add a Post Processors to matercam.) this only if you are updating from an ealer version to a new version. and it also matters what version as not all need to be updated between .for say mastercam X2 and MC X2 MR2.

[cadcam]

Originally Posted by yaoyu look this video http://www.3322.com.cn/readfile.aspx...322_1-22901-35 or

the page comes up in Chines so we can not read.

[yaoyu]

Originally Posted by cadcam the page comes up in Chines so we can not read.

Sorry I don't know
look this Attached Files

[cadcam]

I see there is a EXE file what is it and were did it come from. the Update post is a Dll inside of the Chooks dir in MC.I will not exacute that file not knowing what it is.

[weirdharold]

I did , not paying attention to the exe. on it . Luckily anti virus caught it & healed it. It pay's to pay attention ! Harold