Change recognition: New solid in wrong place

[cncuser1]

I created a *.MCX in MCX2 file from a parasolid (*.x_t) made in Solidworks2007.

I have made changes to the file in SW a couple of times and succesfully done the change recognition.

Now in this last rounnd of editing, when I do the change recogntition, the position of the new solid is offset from the old one. It is not rotated, just off by about 1/4" along two axis

I have tried change recognition with the *.sldprt also but I have the same problem.

Is there something that I should do or not do?

[jmparis]

In MCX MR2 and MR1 I believe you have access to the xform translate dialog upon importing a new solid using Change Recognition.

I sometimes find it easier to create a new file and place the new solid in the appropriate location and then use the new MCX file to import into the Change recognition file.