I recently converted to Solidworks 07 (From 05). I cannot open any SW 07 files in X. Is there anything I can do to rectify this?
I know I can convert to Parasolid or STEP, but I'd prefer to not have more files floating around than I need.
Thanks in advance
you need to have at least MCX2 to bring in 2007 and Mr2 of X2 to bring in 2008 SW
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming