pocket first or contour?

[thecoolsundar]

Hi,


my part looks kinda like a shallow tray with a small projection sticking out

3 questions;

a) Should i run surface rough pocket and then surface rough contour or the other way?

b) When i run rough restmill,it eats into the walls of the tray though i asked it to finish the leftovers of the previous op.

c) The depth of the projection doesn't seem to be enough.can i measure the graphic from verify.

i am using mcam9

Thanks

[cadcam]

Well here is a starter I did the first side look at my ops that are in the tool group cadcam.Sorry did not do the other side as I am tired as it has been along day. Hope this gives you a good start.

Cadcam

[thecoolsundar]

thanks a lot!

this really helps