| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
09-10-2007, 07:35 PM
| |||
| |||
I would set my Z offset about 4 inches above the part and run and see what you get. Get some scrap material and cut the part. Experience is the best teacher hands down.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rotary Milling | binzer | GibbsCAM | 3 | 12-06-2007 09:56 PM |
| Rotary table | Piobaire | HURCO | 0 | 08-22-2007 07:30 AM |
| help with rotary | quemast | GibbsCAM | 1 | 05-27-2007 12:16 PM |
| 4 Axis Rotary | Smackre | Mastercam | 3 | 08-09-2006 11:28 AM |
| Useful for Rotary Table? | Ken Stuempge | Mechanical Calculations/Engineering Design | 2 | 02-12-2006 09:16 AM |
| | |
Linear Mode
