X2 Training options

[mcphilpott]

Hello All - I'm trying to get some guidance on training options for Mastercam X2. My MC distributor says they cannot provide training because it is too old.

After starting my new job, I found we had two seats of X2. We have 2 nice Haas machines that are only being used for manual programming. We previously used MC from version 7 through X2 but the programmers are long gone.

I have 4 co-workers who want to learn how to put a good tool path on our designs and they all design and machining experience. I just need someone to bridge the gap. I am willing to pay onsite or virtual - we have a videoconference setup but I'm not sure where to turn. Any suggestions?

Thanks in advance for your help.

Similar Threads:

• RF-45 Options?
• looking for options
• New EC-400, what options should we have?

[gabedrummin]

You tube...E-Bay for the books..

[avongil]

Cimquest-inc.com will do this for you. They have a very high tech live streaming classroom setup.
Talk to Shawn.

Address: 3434 US-22 #130, Branchburg, NJ 08876
Phone: (732) 699-0400

[Nite2099]

i did not have a good experience with cimquest,,,in new jersey


www.mdmllp.com ------------the engineer that helped me and our customers name is Jesse
probably the most honest ,,skilled engineer in met in mastercam

[avongil]

I worked there for 11 years. They are an honest and technically (not sales) driven company. I would highly recommend them for live video training. They have state of the art equipment and classrooms.

AG

[cadcam]

avongil,
the issue most likely is they will not train on old X2 sofware. we are talking over 10 years old. Even for me to to the training online I would need to install this old version have not used in years but I am a 30 year user and trainer.

[cadcam]

I have sent you a Private msg.