| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-26-2007, 07:03 PM
| |||
| |||
I was wondering if anyone else gets a lot of crashes using MCX2 especially when transforming and then selecting undo. I have had a few times where i have lost all my entities and toolpaths and was wondering if there are certain things that I am doing to cause this. It seems at times to me that it is "crash prone". I have been using it for about 2 months and just wanted to know if this is common or just some things I do at times to bring the problem about.  |
|
#2
03-26-2007, 07:09 PM
| ||||
| ||||
| I have had occasional crashes but overall X2 is MUCH more stable for me than any other version since I started on MCAM 8. I haven't seen anything I'd blame on UNDO or XFORM. My best advice would be to save often and to spend a few minutes setting up "backup files". You'll never know it's there until your file gets hosed but then you'll be glad you set it up. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mastercam x constant crashing | stan Cothran | Mastercam | 102 | 10-11-2007 10:05 AM |
| Help! Mach limit switches - Z crashing, X & Y okay... | InspirationTool | Mach Mill | 4 | 03-14-2007 11:25 AM |
| mach 3 CRASHING! | pleasuretool | Mach Software (ArtSoft software) | 2 | 09-02-2005 07:28 PM |
| | |
Linear Mode
