| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-16-2007, 01:08 PM
| |||
| |||
Hi, I need to make piece(on cnc milling) who need to be changed position after the first machining sequence. I'm asking myself if mastercam is able to set two different top view for the same piece to simulate the whole process. Thx a lot Francis  |
|
#2
03-16-2007, 07:33 PM
| ||||
| ||||
| Yes, you need to use the WCS (Work Coordinate System) for your next operation. Which Version of Mastercam are you using ? |
|
#4
03-17-2007, 02:38 PM
| ||||
| ||||
| Here is a WCS tutorial done by a Mastercam Master  (Hardmill)It was done in V9 but the basic idea still applies... If you can't figure it out for X, maybe I can make you an updated tutorial... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DESKCNC resetting mill table after limit switch is tripped | Eclectic tool | DeskCNC Controller Board | 3 | 07-29-2009 03:40 PM |
| Mach keeps resetting | Moondog | Machines running Mach Software | 7 | 08-15-2006 07:57 PM |
| Zero location resetting mid-run | esmiller | Machines running Mach Software | 5 | 03-03-2006 02:00 PM |
| Resetting the Coodinate System | rweatherly | G-Code Programing | 3 | 12-29-2005 07:53 PM |
| resetting fields | hogman | GibbsCAM | 4 | 05-05-2005 08:22 PM |
| | |
Linear Mode
