Mastercam 2018 no GUI

[martintw]

Hello,

When I open Mastercam 2018 the only thing that I get is few icons on top left corner I am including print screen of what I get.
I tried repairing my installation and uninstalling the mastercam but the problem still exist.

Is there option for resetting every setting ?

Thanks for help.

Similar Threads:

• Need Help!- #2018 Turret Run Alarm (A4.2)
• Mastercam X4 postprocessor for ISEL CPM 2018
• Problem- Mastercam 2018 Machine Definition Menu Management
• Isel CPM 2018 Postprocessor for Mastercam X4
• Need Help!- Starrett CMM HGC 2018-16

[martintw]

So I found a solution to my problem, there is a folder in documents "my mcam 2018" so I just deleted it and the problem is gone.

[cadcam]

So did it rebulid the folder as it is needed. were did you get the 2018 install from?

[martintw]

So did it rebulid the folder as it is needed. were did you get the 2018 install from?

Yes the folder was rebuild after restart of the software. If you are scared of deleting the folder you can rename it.

[cadcam]

Yes the folder was rebuild after restart of the software. If you are scared of deleting the folder you can rename it.

I figured it did as I have told customers before to do this but for other reasons. I have not seen what happened to you happen. was this off the Mastercam Website download?
if so was it the smaller download or the USB large download?