:0001 ( PROGRAM - SPINDLE_MULTI_NOZZLE_BODY_HOLE_WWW )
this is a comment line so just change the comment output to "%" instead of ":"
N124 G0 G28 G91 Z0.
I think I got around this by making the start tool clearance values incremental instead of absolute
give it a try
If you look in your post file
look for a line that starts with
pheader$ #Call before start of file
below this line change
":", e$
to
"%", e$
The above is wrong I have been having a play with the post the line that outputs ":0001"
is this one
*progno$, sopen_prn, sprogname$, sclose_prn, e$
still in the pheader$ section
you can just put a # at the start of the line and it will fix it for Mach3
the post section that outputs
N124 G0 G28 G91 Z0.
is
prefreturn #Refernce return
pbld, n$, *sgcode, *sg28, *sgabsinc, "Z0.", e$
if toolchng = one, pbld, n$, *sgcode, *sg28ref, "X0.", "Y0.", e$
if you can edit the above line to suit your output
as a quick test just comment out the offending code and have a look at the G-Code
prefreturn #Refernce return
# pbld, n$, *sgcode, *sg28, *sgabsinc, "Z0.", e$
# if toolchng = one, pbld, n$, *sgcode, *sg28ref, "X0.", "Y0.", e$
Note you can have the post open in Note Pad and make you'r changes
save the file and regenerate the G-Code you don't need to close the Open post in notepad to see the changes