| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-12-2007, 09:42 PM
| |||
| |||
Hi all, I am new to mastercam(not programming) Just wondering if anyone has a good fanuc post i have a oi-mb control and need a good post have looked around on this forum and did not see anything don't really have the time to edit one because i am putting all my time into learning how to use it....(mastercam v9.1) Thanks for any help!    |
|
#2
02-12-2007, 10:19 PM
| |||
| |||
| Sorry, after doing some digging I have realized that this is not a good way to get the post your looking for, So I am going to edit the mpfan post i allready have. I am going to have a lot of questions i am sure.... thanks for any help i can get..... Sorry again for asking for this post I did not realize it was frowned upon.....  I would delete it but do not know how? |
|
#3
02-16-2007, 01:27 PM
| ||||
| ||||
| what is wrong with the MPfan as I have used this many time for the OM control. Please let us know what issues you have found.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fanuc post | rond16148 | Fanuc | 1 | 12-16-2006 08:41 PM |
| Need post Delcam PowerMILL post for Hardinge VMC 600 II with Fanuc Series oi-MB | littlem | Post Processor Files | 0 | 10-26-2006 05:59 PM |
| in need of a post for 18i-tb fanuc | jas6142 | GibbsCAM | 0 | 10-25-2006 10:24 PM |
| | |
Linear Mode
