Surface mach advise - CNCzone.com-The Largest Machinist Community on the net!

Julian M · #1 01-26-2007, 08:45 AM

Hello everyone, i have attached a part that i am currently working on, i was wondering if someone could offer me some advice on the best way to machine the outside face, that is, the view where the ribs are. I would like to achieve a nice finish on the whole of this area especially the angled faces.

Also just out of interest is there an easy way to prevent mastercam machining the 1.5mm rads running around this part?

Thanks for any help received

JUlian

Mike Mattera · #2 01-26-2007, 04:07 PM

I cant open a Mastercam file. Do you have it in a SolidWorks or Inventor format? If I can see it I can make some suggestions.

Mike Mattera

Julian M · #3 01-27-2007, 02:39 AM

Hi mike, thanks for responding, unfortunately i dont have these formats, i have attached a zip to go for you to try.

Julian

ObrienDave · #4 01-28-2007, 01:26 PM

Try this x_t parasolid file.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Confused: Mach Turn, Mach Mill, Mach 2/3 ?	CanSir	Mach Software (ArtSoft software)	5	02-16-2007 05:41 AM
need advise on HID's	dannystooblue	Machines running Mach Software	5	11-06-2006 04:43 PM
New some advise.	fishmasterdan	CNCzone Club House	3	07-05-2006 07:02 PM
Ballscrew advise...	Dave's_Not_Here	Linear and Rotary Motion	10	06-15-2005 12:21 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)