ok, I have some parts i created in Alibre design. I took them to my wifes work where I have access to MCX but I cannot figure out how to make the toolpaths to cut the parts. I need to create a profile path around the part to cut it out, I can do this with a DXF file, but cannot figure it out on a IGS file.
Can anyone assist me?
Donald
Save your Model or Drawing as an MC File after Importing. Then you should be able to create Tool Paths for your Geometry.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Posting Permissions
LinkBack URL
About LinkBacks
