| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-24-2006, 08:39 PM
| |||
| |||
Hello everyone, I would like to know if it is possible to setup stock in mastercam mill for 3D rough machining of irregular shaped parts (make the software realize where it is cutting the material and where the air is). Help would be very much appreciated. Goran    |
|
#2
12-24-2006, 10:38 PM
| ||||
| ||||
|
__________________ The best way to learn is trial error. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
