engraving

[jaimeoro]

I have a new job that I never done before engraving letters on a 4 axis
but when I do my program and run it on the mill the rotary table keep going around on a circle it does not makes the letters Im using mastercam

[tobyaxis]

Mike Mattera makes CD Tutorials for MC9. He may cover this on one of them.

www.tipsformanufacturing.com

[cadcam]

Are you creating the letters flat were you want them you the can program then as a countour and use the Rotary asis option on the same page as your Tool selection page and use rotary sub and give it the Dia of the part and it will output the 4th for you.

if you share your file I can set it up for you then you can review this or I can creat a simple sample.