I tried it all, any help please to get a surface on this heel.
Similar Threads:
- Need Help!- swept
- VM10 "swept surface"
- Problem- Swept Surface Error
- Need Help!- Swept 2d Contour
- Swept Surface problem
Sure.
Try a coons surface.
I tried, it didn't work, thank you though.
Use Swept for contour. and Ruled for sides.
Trying to upload file?
Nice job ? How did you create the 2 side splines
I made a blended spline
of 1.8 and (-0.01)
is this close to what you did
If so the surface is highly dependent on the spline
would I be correct in saying this or have I got it all wrong.
Update I think I got it all wrong
would it be curve on 1 edge
Last edited by squirrel_41; 03-26-2015 at 10:52 AM. Reason: more testing
Yes, curve on 1 edge.
I got it, thank you all. 2 rail swept, then mirrored surface. Then split and trimmed.