Step over in Dynamic Core X7 Toolpath

[FMJ]

The stepover amount is ignored in the corners ( see picture ). How do you control this?

Thanks!

FMJ

Similar Threads:

• newbie question on step by step cutting setup/ process in Mach3
• Toolpath Scallop - What is the Step down?
• Dynamic Core program really long.
• dynamic core mill inside to outside
• Need Help!- Step/Direction pins should be Step FWD and Step BACK

[Bisquit69]

It's not ignoring the step over. It's keeping the tool load the same so it's doesn't shock the tool. As you go around the outside of a corner the circumferential engagement drops. So mastercam takes a little bigger cut to keep the load the same. I use it all the time and love the results. Great tool path.