| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-24-2003, 04:44 PM
| |||
| |||
| library of wood tools Wondering if there is a pre-existing tool library of router bits more akin to wood working for V9. I have created a few on my own but I guess I am just lazy and want to make it easy.
__________________ We are open 24hrs. - just not in a row.    |
|
#2
11-25-2003, 08:20 AM
| ||||
| ||||
| Mike are you useing Mastercam mill? There is mastercam Routor that contains a hole libary. I will have to see about exporting out from Router to Mill.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
#5
04-23-2004, 05:47 PM
| ||||
| ||||
| I have found that I can pull my libary from router to Mill and use this tool list... If you have the new disk you can tell during the install the router software. Of couse sense you key will not let you run Router ,but you can go to NC utiltis and change the libary and go to the tools dir in router. grab te libary you want... Hope this helps.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
