New MasterCam x user and need help

[ahmedsamy_81]

Hi guys
i'm a new (MasterCam X) user but i haven't a postproccessor for NUM750 controller, can anyone help me to get it?
how i can make a postprocessor?

[Matt Berube]

What's an NUM750 ?

What did your reseller say about it ? You did ask them first, right ?

here's their website...... http://mastercam.ncs.co.il/

[ahmedsamy_81]

I'm already asked for it but they didn't reply
but i have a postproccessor fo older version and not fully compatabile with my controller.

[Matt Berube]

Just a suggestion...
If you have an older version (9 I assume ?) post that sort of works, why not use Mastercam X's post processor update ?

After that you could post questions about what issues you have with the post and how to fix it...

There are many post wizards that frequent these forums.

Note also that there is a specific Mastercam post area in this forum.

[ahmedsamy_81]

how i can find post wizards that frequent these forums.
and i need to learn how i can do it myself ,where i have 7 old version machines with some different controllers ,that may be difficult to find a post fully compatabile with each controller.

[JaneGao]

you can use MasterCam's defult post ,just change your control in arc use Num70,it is easy

[cadcam]

Have you tried updating the post and see if it works?
learning to adjust a post you do not learn over night as there are allot of variables for diffrent machines.
Is this a DMG machine by chance?