Did you check under Configuration > CAD Settings > Preview >Maintain? You might want to spend some more time reading the help file (press F1 key). Almost all the information is in there.
ANYONE KNOW HOW TO CHANGE THE XFORM DEFAULT SETTINGS?
I HATE EVERY TIME I HAVE TO ROTATE OR ANYTHING ELSE, I HAVE TO CHANGE IT TO MOVE, AND NOT COPY. REALLY ANNOYING.
Similar Threads:
Did you check under Configuration > CAD Settings > Preview >Maintain? You might want to spend some more time reading the help file (press F1 key). Almost all the information is in there.
HEY TXCNC, HOW YOU BEEN?
NO I HAVENT LOOKED UNDER CONFIG YET. I THOUGHT IT WOULD BE UNDER CUSTOMIZE. BUT THOUGHT I WOULD CHECK HERE BEFORE I STARTED CHANGING ****. I WILL LOOK INTO IT TOMORROW. THANKS FOR THE REPLY. GOOD TO SEE YOUR STILL HELPING OUT.
I always have to ask what version as there are changes over the years. as it is not the same from say v8 and v9 then again from MC-X to MC-X6
Also the newer versions will remember your settings thru out your session once you use it once. there are no direct option for setting to Move vs Copy.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Turning Product Specialist for a Software Company, contract Programming and Consultant , Cad-Cam Instructor of Mastercam .