Does any one know how to create manual tabs in MasterCAM X6 for Solidworks in contour toolpath? I am so frustrated! I can create tabs automatically but not able to change their locations. I need to place them in the probably spots.
As you see the Manual option is gray out. I can't do nothing to it. In MasterCAM X6, I am able to change the location in geometry by right click it. But in MasterCAM X6 for Solidworks, it seems like that function is disabled.
Can any one help? Thanks!
you need to make the square points were you want them and check that box or use the Manual and use the option of picking an edge and dragging the along for position.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming