Hey, so my school recently bought a plasma table and we have yet to cut to scale. it seams that whatever we design on MasterCam X6 comes out some percentage bigger than what we design. we are trying to figure out if its in the machine or in the gcode, but if anyone uses that table with MasterCam X6 could give us the post that they use and works that would be perfect. thanks for looking!
Last edited by G&T_Machine; 05-09-2012 at 03:18 PM.
Contact the Educational division of Mastercam in Gig harbor they have posts for the schools.
you may want to start with the local educational mastercam dealer first.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming