extended work offsets

[Joesph Jackman]

6 gives you g54 p1. what forces an increment to g55 p1?

[MMTZ]

G55 P1?? What control are you working with??

If it is a Fanuc, I don't think there is a G55 P1, if you want to keep on using extended WO, you will go with G54.1 P1 thru P59 I think.

So 1st offset G54.1 P1, then G54.1 P2 , G54.1 P3 and so on thru G54.1 P59.

HTH

[Joesph Jackman]

fanuc. extended offsets using anything other than g54 p_ are not available with fanuc controls?

[txcncman]

For Fanuc, it is G54.1 and P. For Haas it is G154 and P.