Creating tabs in Mastercam x6

[Stevetotheo]

Can anyone give me the run down on how to create tabs? Im trying to cut basically a square out of a sheet of plexi and every time I make a contour path it makes the tool path but not the tab even if I select the option to add 4 tabs.

Thanks for the input.
Steve

[Rstewart]

I always use the Manual placement tab to put em where I want them.

Just make sure your giving them a thickness and width.

click the geometry> move the mouse to correct location > then press enter, repeat for as many as needed.

[txcncman]

Are you putting in thickness and width parameters?