dynamic core mill inside to outside

[Jim Rush]

I have a part that is approx 10" od,8" id and 1" thick. I have to cut a pocket with some flats that is around 9" id and 1/2" deep. Can you use dynamic core mill to cut inside to outside? What is the best way to do this? thanks, Jim

[neurosis]

Use "dynamic area" for pockets.

[Jim Rush]

How do you get the tool to enter from the inside rather than ramp in the pocket area? The inside of this pocket is open. thanks, Jim

[Joesph Jackman]

I have a part that is approx 10" od,8" id and 1" thick. I have to cut a pocket with some flats that is around 9" id and 1/2" deep. Can you use dynamic core mill to cut inside to outside? What is the best way to do this? thanks, Jim

yes, if you create extra boundaries. attach a file if you need more specifics.

[txcncman]

Select Approach and Retract points. If the center is totally open, why use Core Mill? Why not use Contour with multi-passes/depth cuts? Core Mill would be for when you have a cast pocket with a cast island and you want to machine both on one operation.