LinkBack URL
About LinkBacks
Check Overlap fields in Cut Parameters. & then see the attached files.
| | |
I have a simple imported 3d solid that i have created curves on. IT is just a simple flat surface that stops when it reaches a step up to another surface. Problem is the facing toolpath keeps extending into the next solid surface. Ideas? File is a rar.
Check Overlap fields in Cut Parameters. & then see the attached files.
Try this.
http://www.kirkcon.com/
this should be cut as a 2d contour not a facing as you are not facing and over laping the part.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming
Technically correct, every op has its own place.Originally Posted by cadcam
Still if you can tweak a few things some "out-of-place" ops can get you the same results faster.
I agree as I have done things with MC that the system would give errors in the past but pushed it thru anyway to get what I wanted out of the code.
in the older days we did not have a third of the options we have now. Late 80,s early 90,s
So keep pushing and trying thinks.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Owner, contract Programming and Consultant , Mastercam Instructor and on line trainer at www.eapprentice.net
Some tips: http://www.youtube.com/PrecisionProgramming
Posting Permissions
| | |
