Cannot find it...

[Eritex Inc.]

Been looking for something that is probably right in front of my face. I am doing quite a bit of 3D milling but need smaller file sizes. Guess what I need to get rid of?

%
O0( LS1FI1 )

( LS1 FUEL INJECTION INTAKE STEP 1)
( 9-20-2011 )

( T9 | 1/8 CENTERDRILL | H9 )
( T7 | 1/8 DRILL | H7 )
( T2 | 1/2 INCH FLAT ENDMILL | H2 )
( T1 | 1/8 BALL ENDMILL | H1 )
( T4 | 1/8 FLAT ENDMILL | H4 )

N100 G20
N110 G0 G17 G40 G49 G80 G90
N120 T9 M6
N130 G0 G90 G54 X.475 Y-1.39 A0. S6000 M3
N140 G43 H9 Z.1
N150 M8
N160 G99 G81 Z-.165 R.1 F20.
N170 X-.475
N180 Y1.39
N190 X.475
N200 G80
N210 M5

Yup, I need to get rid all those N100, N110, N120, etc numbers in X2. File sizes are reaching 5MB+ and my Haas seems to error out (seems to not be able to load entire program) on larger posts.


Thanks again for any help

[Steve Arteman]

In mastercam screen, go to settings drop down, machine definition, (top of page Icon) control definitions,go to NC output ( list on left) you will see Sequence numbers turn it off by unchecking box and saving the file at the top of page.

Steve
www.cad2cam.net

[Superman]

Or if you just want them gone from that program

when it ( the posted NC program ) opens into the editor----just remove the Sequence numbers, this is a function within the Cimco & in the Mastercam editors