Mastercam 2 Rail Sweep? - CNCzone.com-The Largest Machinist Community on the net!

furry · #1 09-04-2005, 06:42 PM

Can mastercam perform 2 rail sweeps? I can do these in rhino/pro-e but can't get mastercam to do the same.. Only seems to work with a single rail.

Any ideas,example appreciated.

PROTOTRAKFAN · #2 09-05-2005, 08:44 AM

Yes you can achieve what you want to do with Mastercam. You can use the swept function 3 way's (that I know of) - one across one along, one across two along, two across one along. One across two along would be equilvalent to using Rhino's sweep two rails.....
Patrick

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)