Need Help!- corner picking a 60 deg blade on a 4th axis

[drivetrain2]

Does anyone corner pick. The part is made out of D-2 tool steel. It is 14." o.d. 13.5 i.d. part with a 60 deg cutting knife blade on it. The blade is .100 high and .06 wide at the bottom. The top of the blade is .002/.003 finished width. I have to pick out 90 deg corners with a 60deg 3 flt burr that comes to a point. Any ideas..... I need help. I have a 14,000r.p.m. spindle to work with also...

keith

[Delw]

is grinding a option?
a 60º at that width is going to warp some with that type of tool.
I would thing using an flat endmill and turning the 4th to the angle need would be best and lest tool pressue or even surfacing it with a small ball endmill like a 3/64.
for example leave .010 stock and surface over the edge with a small good quality endmill.
NOT length wise surface width wise down the length.

Hope that makes sence.
Delw