| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-21-2011, 10:49 PM
| |||
| |||
I would like to mill 3 spiral blades, 120 degree apart, which wraps around a 6 inch round stock material. For example, 36 lead, 1 inch wide, 0.3 inch deep from top OD. If I use contour or rolldie tool paths, I will get taper side walls. (bigger on top and smaller at root of blades). Technically centre of tool should be of centre on Y+ and Y- by width of blade and tool radius. How can I make these side walls are parallel (not toward part centre line)?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Dual Y Axis Slave A Axis Homing Problems | guy2b1 | Calibration & Measurement | 4 | 03-03-2012 04:06 PM |
| MasterCam X3 post for Acramatic 2100 5-axis with A B axis | gamma500 | Mastercam | 0 | 03-21-2011 07:33 AM |
| Compare Catia and MCX2 for multi axis lathe/4 axis mill | bob1112 | General CAM Discussion | 0 | 10-10-2008 07:15 PM |
| One axis (z-axis?) computer controlled testing device | TsThorsell | Stepper Motors and Drives | 3 | 02-07-2008 12:38 PM |
| New Design - Hybrid 3-Axis Router/4-axis Foam Hot Wire Cutter | the__extreme | CNC Wood Router Project Log | 3 | 02-26-2007 02:58 PM |
| | |
Linear Mode
