Need Help!- "N" numbers and sequence gaps

[Xarragh]

I Want to change the posted programs to start a N10 and to Continue as N11,N12,N13...And so on.

Is the minimum N100 with a gap of 2? I know where to change it in NC utilities under screen/configure.

The cincinnatti Vickers is doing something funky with the programme near the end of the programs

Cheers

[psychomill]

I'm assuming you're using "X" of some version? You can change this on the Properties page in your Operations Manager for your toolpaths. Select the Tool Settings tab and look in the lower right corner area. This can also be preconfigured in your Controls Definition of the machine type....

[Xarragh]

Hi, thanks man, i'm using Version 9, Whenever i change it it doesn't reflect in the Nc Files.

[ObrienDave]

You need to change the Default toolpath parameters.

Go:
NC utils
Def. ops
Defaults

Open DEFAULTS.DF9

This is where Mcam gets the toolpath info the very first time you use any toolpath.
Subsequent uses of the same toolpath ( contour, pocket, etc.) take the values from the previous use.
This is where you also set defaults like coolant, clearances, retracts, etc.

Unfortunately, you will have to change the default parameters for ALL 44 toolpaths.