| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-28-2011, 06:13 PM
| |||
| |||
Iam running Mastercam x4 with windows 7.When I verify my toolpaths and I try to change the view when the tools is running or even after the tool is finished it gives a warning says Graphic view is not allowed at this time.Is there a function i can turn on or off ,i have never seen this before .After the warning pops up i click ok at the bottom of the box and it goes away but it still will not let me change views?? HELP?????Does any one have any suggestions  |
|
#3
04-29-2011, 08:05 AM
| ||||
| ||||
| Use the Dynamic rotation to move the part around to view.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Who is allowed radios in their shop? | DAB_Design | Polls | 75 | 04-13-2012 02:19 AM |
| Selling Not Allowed in Forums | frostheave | OneCNC | 0 | 03-26-2009 12:19 AM |
| am i allowed to ask this? | StinkFish | CNC Tooling | 5 | 11-23-2007 04:46 PM |
| No laughing allowed... | Dave's_Not_Here | General Electronics Discussion | 6 | 06-08-2005 01:16 AM |
| | |
Linear Mode
