| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-18-2005, 07:04 AM
| |||
| |||
Good Morning, I am wondering if anyone has had any experience with using MasterCam and a Maho with a Phillips control (432) that is a five axis machine with two spindles. One horizontal and one vertical. Is there a post processor out there that can output the correct code with no manual edits required? Any help is greatly appreciated! Thank you. Christopher  |
|
#2
09-07-2005, 08:06 AM
| |||
| |||
Talk to your reseller. 5 axis posts are very machine specific unlike all of the other posts that came on your original install disc. There is a generic 5 axis post on the disc though that you can prolly modify to get the poutput you are looking for. Jim Phinney Bay Machine Works |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
