| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-24-2011, 09:33 PM
| |||
| |||
| I'm playing with a post for a haas sl20 with servo300 bar feed the nc code to push part is as such "G105 J1.0 K.5 . J is push length K is min clamp if less than .5 to clamp it will load new bar. My question is. Is there a way without using custom pram. To set the J since standard options only start z and end z . Can you do math in a post or am I looking at it all wrong any help would be great would be even greater if someone has the code for the bar feed and could share with me  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with css,feed... | CNCbook | Mastercam | 5 | 11-12-2010 09:39 PM |
| feed and rpm help | forsale78 | CNCzone Club House | 1 | 08-16-2010 10:31 PM |
| Okuma mill feed rate jumps to rapid feed | easyguy97 | Okuma | 6 | 12-20-2009 04:14 AM |
| Feed ? | Ken_Shea | General Metalwork Discussion | 12 | 10-31-2004 06:37 PM |
| Where is RSS feed? | samualt | Forum Questions or Problems | 1 | 08-04-2004 07:04 AM |
| | |
Linear Mode
