X2 For Sale

[TheBigJW]

I am just so sick of this company.

X2 Mill Level 1 - Lathe and Wire for sale. All on one seat.
You must take all three.

It will cost you a bloody fortune to have any products taken off this dongle. I have the quote if you want a copy.
Even if you only want one seat of mill you will have to pay four thousand dollars to get lathe and wire off the dongle.
So to go forward you have to pay maintenance on all three products of pay four thousand dollars to get the other two off.

Sim# 74448

After years of extreme agony I want to get my self something real nice.

NX - Esprit - Solidcam

Oh ya. It's a new USB dongle. My dealer even screwed me on the cost to replace that...

Oh ya. It's a Canadian version so the maintenance will be 40% more than you may be paying in the US.

Best offer.

John

[beekeeper]

i didnt think mastercam software was transferable from the original owner. I have been told you basically are buying the rights to use the software and is non transferable. Mastercam resellers will not suport the new owner

[TheBigJW]

Originally Posted by beekeeper i didnt think mastercam software was transferable from the original owner. I have been told you basically are buying the rights to use the software and is non transferable. Mastercam resellers will not suport the new owner

I think that is the case but you will still be able to use the software. Just no support. Not sure what support you would expect anyway.

I have a plan for my next large cam software purchase. I am going to start a numbered company and have that company buy the software as it's only asset. This way in the future when I outgrow the software or the software company stops supporting it I can just sell the corporation.

That way the new owner has many options.

John