| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
01-25-2011, 09:27 AM
| ||||
| ||||
| http://www.cnczone.com/forums/post_p...processor.html That is a tough one, having done one for that control. Robert
__________________ The beaten path, is exclusively for beaten men.  |
|
#3
01-25-2011, 10:14 AM
| ||||
| ||||
| You should just get one from your dealer...at least to start with, then if you need further tweaks, try emastercam.com. I'm not sure about the Okuma's since they seem to be different than most, but Mastercam may have a basic post to get you rolling.
__________________ Tim |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
