| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-22-2005, 06:43 PM
| |||
| |||
Can someone please tell me the significance of files w/ extension ".err". I see no ill side affects when machining but evertime I produce g-code (nc files) from mastercam this file is generated also. Thanks...Norman  |
|
#2
07-22-2005, 06:50 PM
| |||
| |||
| Everytime? .err is an error file, as in something is wrong. Usually something with your post or the way a toolpath took place. Open it up the .err file and read it. It usually will give you the 'error message' of what went wrong.
__________________ It's just a part..... cutter still goes round and round.... |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
