| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-05-2011, 12:24 AM
| |||
| |||
Hey all, Is there a way to change toolpaths in mastercam x3 to make the pocket floor as clean as possible with the true spiral cutting path? I have a pocket with an island, and as the mill cuts around it it crosses the path of the spiral. I want the spiral in the irregular pocket to be undisturbed except for the finish pass. I don't care if its less efficient. Thanks!  |
|
#2
01-09-2011, 02:50 PM
| ||||
| ||||
| try using Morph pocket
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) Cadcam Mastercam Instructor , Programming Consultant and ME (Manufacturing Eng) |
|
| Tags |
| mastercam x3 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- pocket milling - don't want finishing pass | jay_dizzle | BobCad-Cam | 3 | 10-15-2010 03:13 AM |
| Pocket Floor Finishing? | Donkey Hotey | Mastercam | 14 | 03-01-2008 11:56 AM |
| Finish Cutting pass. | Greg Maxwell | Mastercam | 2 | 11-21-2007 11:10 AM |
| 32 finish at bottom of pocket | BROCD | General Metalwork Discussion | 3 | 03-03-2006 07:26 AM |
| Z level finishing does not finish final depth pass | TPPJR | OneCNC | 13 | 01-10-2006 08:22 AM |
| | |
Linear Mode
