cutter compensation in analam

[armcoracing]

hi guys im using mastercam 9 with an analam controlled vmc but when i code up using control in compensation type i dont get any g41 basically no cutter comp on in my program,when i change my pst to fanuc i do get the g41/g40 and the same in heidenhain RL/RR,is this something that analam wont do or am i not doing something thx.

[Mike Mattera]

Probably the post. I have a post for the 3300/3000/1100 control. I know it works.
Postprocessors

Mike Mattera

[armcoracing]

thx for your reply mike

[Exodus8931]

Originally Posted by armcoracing hi guys im using mastercam 9 with an analam controlled vmc but when i code up using control in compensation type i dont get any g41 basically no cutter comp on in my program,when i change my pst to fanuc i do get the g41/g40 and the same in heidenhain RL/RR,is this something that analam wont do or am i not doing something thx.

ziptogo a sample file, and post it, can't help you out now, no files posted.

[armcoracing]

Thx Exodus ive attached a sample file see what u think,i tried using mpan112x/113x and mpanorad in my post but it dosnt work as im using a 6000 series control so im using mpan5300 its probly not the correct post but it works,im thinking is there something in the gineric code i have to change,thx.