x4 graphic issure - CNCzone.com-The Largest Machinist Community on the net!

steven97 · #1 11-09-2010, 10:30 PM

After install x4 to my laptop (win7),when I draw an entity, I can not
see it unless I scroll the middle wheel of the mouse to zoom it in or out , now the entity is visible. So what is the problem ?

Jhjr · #2 11-10-2010, 01:40 AM

Look a couple of topics down. Your answer should be there.

steven97 · #3 11-10-2010, 04:26 AM

Can you little more specific which one and where I have to make a change,because I just start to use the X4. Thank

Superman · #4 11-11-2010, 04:18 AM

http://www.cnczone.com/forums/master..._7_laptop.html

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Graphic Artist	frickles	Employment Opportunity	0	11-15-2007 10:05 AM
Any Graphic Artists out there?	zcases	Employment Opportunity	5	10-19-2007 08:48 PM
Graphic display 10T	guhl	Fanuc	13	10-18-2007 08:39 AM
Optical isolate Xylotex issure	monte55	Xylotex	1	10-25-2006 10:43 AM
G Code to Graphic	AJFab	G-Code Programing	8	06-01-2006 07:20 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)