Need Help!- control def. arcs to linier

[Imm]

does anyone have any good setting for the arc error checking area of the arcs page in x-x4. In the linier conversion of arcs the line segments are longer in mcx than they are in mc9. using the same file . or should they be the same for x y and a axis. using the same post that was updated from MC9 to MCx

please help

Richard

[ObrienDave]

This problem has nothing to do with the post.
It has everything to do with the linear tolerance setting.
The difference you are seeing is because your X version setting is larger than the V9 setting.

[Imm]

ObrienDave

we checked the settings on the tolerance page in the system config. ver X has two more options than v9 but they are set the same no change.

thanks for tring

richard

[Jhjr]

Look in your control deff and machine deff. I think there may be a setting in there for tolerance.

[Superman]

Are these line segments on the geometry or toolpaths ?

If geometry,,,it should be the tolerance settings that you have been looking at
if toolpaths,,, look at the filter settings in the operation, and the arc settings in the control definition file