Vertical Text - M8

[Swemill]

Is it possible to do a vertical text with Mill 8, that is with "centered" letters. I'm only able to do text with the start in a vertical line.
Looks not good because of the different wide of letters and i must "correct" it manually.
The project is to engrave an vertical "tag".

Thanks in advance!

[Swemill]

Nobody who know how to do this, or if it's even possible to do "automaticly"!?

The "problem" could be seen below:

M
I
L
L

[Superman]

It's only a wild suggestion, but it may put you in the ball-park

Use "create drafting note" with the text set to be vertical, after placing it in the correct location, you would then "explode" or convert it from a drafting entity to lines and arcs. Then you can put a tool to that geometry.

[Swemill]

YES Superman, that worked perfect!
I have tried with drafting note before but couldn't get any toolpath and thought that it wasn't possible and was only for drawing / prints.

I first did a "Break" - Text, and then got arcs from filtering the conture toolpath but did you mean another way?
My program is not in english and is kind of hard to translate... The "help meny" does not work with Vista either!

However thank you very much for your help!