Need Help! very green person needs help with lathe making a crown - CNCzone.com-The Largest Machinist Community on the net!

bobrob · #1 06-18-2010, 09:23 AM

Iam just learning or trying to from book i have i need to turn a crown in middle of part how would i even draw this out ? I tried programing it manually with a canned cycle it did all my roughing passes on the first side but when it went to the oppisite side of crown it just took a finish pass . Is there any one that has some examples i can look at ? actually the part looks like a flame . its .890 long .300 dia with a 1.550 radius . Iam using Master Cam 9 and also have acess to master cam x3

Thank you for any help or examples in advance

littlebrewman · #2 06-24-2010, 01:03 PM

please send me your drawing and i will try to help. please send me pm and i will give you my email to send it to. if you can send me a dwg file of the part.

littlebrewman · #3 06-30-2010, 10:56 AM

I sent you an email with a toolpath that may help.take a look and let me know.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem- CROWN VIBRATION	jw12	Okuma	5	05-20-2009 10:51 PM
Looking for anybody with OKUMA CROWN SB	JINX222	Okuma	2	03-18-2008 03:29 PM
Crown, Hot off the table	robinsoncr	MadCAM	2	11-04-2007 04:29 PM
Making a lathe	the4thseal	General Metalwork Discussion	2	09-10-2006 04:15 PM
a head + crown	D5zUga	Rhino 3D	0	01-21-2005 01:36 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)