| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mastercam Discuss Mastercam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-14-2010, 09:06 AM
| |||
| |||
im trying to cut a groove for a part, im ramping down in the center of the groove. but when i try to finish the inside and outside using a contouring toolpath, with a perpendicular entry.(half the groove diameter, so it starts in the center) it posts a program cutting into the material. however, works fine in mc10??  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- mastercam PP problem | basim | Post Processors for MC | 4 | 12-13-2009 08:27 AM |
| Problem- Mastercam offset problem | kcritch | Mastercam | 4 | 11-28-2008 05:55 AM |
| MasterCAM X Surface Contouring | rodzilla | Mastercam | 9 | 01-18-2008 03:42 PM |
| Mastercam problem | deckhand | Mastercam | 6 | 11-22-2006 11:08 AM |
| Problem/mastercam Config | DELL | CNCzone Club House | 0 | 07-20-2006 06:03 PM |
| | |
Linear Mode
